LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Custom >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC Systems - Automatic >> Repair Instructions >> Blower Motor Control Processor Replacement >> Removal Procedure

Removal Procedure

  1. Remove the right side IP insulator Panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
    2. Fig 1: View Of Electrical Connector For Blower Motor Control Processor
    GM295319Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector from the blower motor control processor.
    3. Fig 2: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the blower motor control processor electrical connector from the blower motor.
    4. Fig 3: View Of Blower Motor Control Processor
    GM295320Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The opening to the blower motor control processor is slotted. Access to the blower motor control processor opening is limited.
  4. Loosen both of the forward bolts.
  5. Remove the rearward bolt.
    6. IMPORTANT: Tilt down the rear of the blower motor control processor.
  6. Remove the blower control processor.
scientia non olet · About LEMON Manuals