Installation Procedure
- Install the insulator to the battery.
- Install the battery (3).
- Install the battery retainer (2).
- Install the retainer bolt (1) to the battery.
Tighten: Tighten the bolt to 18 N.m (13 lb ft).
- Connect the positive battery cable to the battery.
Tighten: Tighten the bolt to 15 N.m (11 lb ft).
- Install the right front diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
IMPORTANT:
Do not tip the battery more than 40 degrees during installation.
NOTE:
Refer to Fastener Notice in Cautions and Notices.