LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Custom >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Repair Instructions >> Wiper Motor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Wiper Motor & Screws
    GM815221Courtesy of GENERAL MOTORS CORP.
  1. Install the water shield and shaft seal onto the wiper motor.
  2. Position the wiper motor to the wiper drive system module.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the wiper motor screws.

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

  4. Install the wiper drive system module. Refer to Wiper Drive System Module Replacement .
  5. Install the wiper motor crank arm. Refer to Wiper Motor Crank Arm Replacement .
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
scientia non olet · About LEMON Manuals