LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Base >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Steering Wheel, Shaft & Nut
    GM294367Courtesy of GENERAL MOTORS CORP.
  1. Route the SIR connector through the steering wheel.
  2. Align the scribe mark on the steering wheel with the slash mark on the steering shaft.
  3. Install the steering wheel.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the steering shaft nut.

    Tighten:  Tighten the nut to 45 N.m (33 lb ft).

  5. Install the Inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  7. Inspect the operation of the following components:
    • The horn
    • The steering wheel
    • The steering wheel controls
scientia non olet · About LEMON Manuals