LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Base >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Shift Lever Replacement >> Installation Procedure

Installation Procedure

    IMPORTANT: The shift lever seal must be installed to the narrow end of the shift lever.
  1. Install the shift lever seal (2) onto the shift lever assembly (4).
    2. Fig 1: View Of Shift Lever, Seal (Boot), Screw & Upper Trim Cover
    GM419648Courtesy of GENERAL MOTORS CORP.
  2. Install the shift lever assembly (4) to linear shift assembly.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the shift lever screw (3) into the shift lever assembly (4).

    Tighten:  Tighten the screw to 20 N.m (15 lb ft).

  4. Slide the shift lever seal (2) down the shift lever assembly (4).
  5. Align the shift lever seal into the steering column trim covers.
  6. If necessary, install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals