Conditions For Running DTC

DTCs P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0201-P0206, P0300, P0336, P0403, P0404, P0502, P0503, P0506, P0507, P1106, P1107, P1112, P1113, P1114, P1115, P1121, P1122, P1374, or P1404 are not set.
The ignition 1 signal parameter is 11-18 volts.
A/C status does not change.
Transaxle range does not change.
TP angle is less than one percent.
Intake Air Temperature (IAT) is -40 to 248°F (-40 to 140°C).
Engine Coolant Temperature (ECT) is more than 167°F (75°C).
Engine speed is 1100-1400 RPM.
The MAP sensor parameter is 17-43 kPa.
The MAF sensor parameter does not change more than 2 grams per second.
The BARO parameter is more than 74 kPa.
The TP sensor parameter is less than 1 percent.
The VSS parameter is more than 28 MPH. during deceleration.
Vehicle will need to be driven above 50 MPH, and then allowed to decelerate. When the vehicle is decelerating while meeting all of the criteria, the PCM will enable the test to run. As the test is running, you will see the desired EGR parameter and the EGR position sensor on the scan tool change from zero to a calibrated value above zero. Additionally, the EGR Flow Test Count parameter on the scan tool will increment when each EGR flow test is completed.