LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2003 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1290 (Lighting Systems) >> Repair Instructions >> License Lamp Bulb Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Tail/Backup Lamp
    GM506449Courtesy of GENERAL MOTORS CORP.
  1. Install the license plate bulb into the lamp housing.
  2. While supporting the tail/back up lamp assembly, install the tail/back up lamp harness grommet to the rear compartment lid and install the tail/back up lamp.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the tail/back up lamp fasteners to the tail/back up lamp studs.

    Tighten:  Tighten the tail/back up lamp fasteners to 6 N.m (53 lb in).

  4. Connect the tail/back up lamp electrical connector.
  5. Connect the tail/back up lamp harness connector and clip the connector to the metal edge of the rear compartment lid.
scientia non olet · About LEMON Manuals