LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2003 >> Century Base >> Repair and Diagnosis >> Suspension >> Wheel Alignment Specifications & Adjustment Procedures >> Repair Instructions >> Front Toe Adjustment

Front Toe Adjustment

  1. Perform the following steps to remove the small seal clamp:
  2. Position the steering wheel in the straight ahead position.
  3. Loosen the hex nut on the tie rod (2). Turn the tie rod shaft (1) in order to obtain the proper toe angle. Refer to WHEEL ALIGNMENT SPECIFICATIONS  .
    Fig 1: Locating Hex Nut On Tie Rod
    G01569397Courtesy of GENERAL MOTORS CORP.
  4. Confirm the number of threads showing on each tie rod end is nearly equal.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Confirm that the tie rod ends (3) are square before you tighten the lock nuts (2).

    Tighten 

    Tighten the hex nuts at the tie rod ends to 68 N.m (50 lb ft).

    IMPORTANT: Ensure the seals do not twist.
  6. Install the seal clamps.
scientia non olet · About LEMON Manuals