Test Description
The numbers below refer to the step numbers in the diagnostic procedure.
- 2 - A normally functioning HO2S 1 voltage signal will fluctuate above and below the bias voltage amount.
- 6 - This step inspects the HO2S 1 signal circuits from the HO2S connector and the PCM connectors, including the low reference loop between the PCM connectors.
- 8 - This step inspects for correct HO2S 1 heater circuit operation up to the HO2S connector. The heater low control is controlled by the PCM. The engine must be running to enable the HO2S heater.
- 9 - The conditions listed in the test may contribute to the failure of the HO2S. The conditions listed apply only to this type of failure.