Test Description
The numbers below refer to the step numbers in the diagnostic procedure.
- 4 - This step isolates the condition. If the test light blinks, the PCM is providing ground to the fuel injector.
- 5 - This step tests if a ground is constantly being applied to the fuel injector.
- 6 - This step isolates the circuit between the multi-way connector and the PCM. An open or short to voltage on the fuel injector control circuit will not allow the test light to blink.
- 8 - This step inspects for fuel injector harness damage between the multi-way connector and the upper intake manifold. Careful inspection may isolate the condition before removal of the upper intake manifold.
- 13 - This step isolates the circuit between the multi-way connector and the fuel injector. A short to voltage on the fuel injector control circuit will set this DTC.