Programming Transmitters

NOTE: Do not operate or program transmitters in vicinity of other vehicles that are in keyless entry program mode. This prevents programming of transmitters to incorrect vehicle.

NOTE: All transmitters which are to be recognized by Remote Control Door Lock Receiver (RCDLR) must be programmed in a single programming sequence. If system is placed in program mode, all previously programmed transmitters will be erased upon receipt of programming signal from first transmitter. Up to four transmitters may be programmed.

Connect scan tool to Data Link Connector (DLC). DLC is located on lower left side of instrument panel, near steering wheel.
Turn ignition switch to RUN position.
Use scan tool REMOTE FUNCTION ACTUATION SPECIAL FUNCTION. Program key fobs in order to place Remote Control Door Lock Receiver (RCDLR) in program mode. Doors will lock and then unlock in order to confirm program mode.

NOTE: Scan tool must stay connected until all of transmitters are programmed.

Press and hold lock button and unlock button simultaneously on one transmitter. After a delay of 15 seconds, doors will lock and unlock in order to confirm programming of that transmitter.
Repeat previous step in order to program up to 4 transmitters.
Remove the scan tool.
Operate the transmitter functions in order to verify correct system operation.