Programming Security Feedback

NOTE: If vehicle is equipped with Driver Information Center (DIC), programming of this feature must be through DIC. See PROGRAMMING SECURITY FEEDBACK USING DRIVER INFORMATION CENTER .

NOTE: For mode operation information, see SECURITY FEEDBACK under OPERATION.

NOTE: This procedure only changes mode for transmitter used to change mode. Procedure will need to be repeated for second transmitter.

To change security feedback mode, perform the following:

Close all doors and turn ignition switch to RUN position. Keep all doors closed throughout this procedure.
Press and hold lock on driver's power door lock switch throughout this procedure. All doors will lock.
Press trunk button on transmitter. Security feedback will remain in its current mode. Horn will chirp as feedback.
Press trunk button again. Each time trunk button is pressed, security feedback will advance to next mode, and horn will chirp as feedback.
Release driver's power door lock switch. Security feedback will remain in most current mode selected.

To verify mode selected, remove key from ignition and close all doors after exiting vehicle. Press lock button on transmitter to be verified and confirm appropriate feedback. Repeat with unlock button.