LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2000 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Power Steering System) >> Repair Instructions >> Power Steering Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Power Steering Pump Mounting Bolts
    GM464479Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering pump to the engine.
  2. Install the power steering pump retaining bolts.

    Tighten:  Tighten the power steering pump retaining bolts to 25 N.m (18 lb ft).

  3. Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
  4. Raise the vehicle.
  5. Connect the wiring harness to the power steering pump.
    6. Fig 2: Removing/Installing Power Steering Hose Fitting
    GM254768Courtesy of GENERAL MOTORS CORP.
  6. Connect the power steering pressure hose to the power steering pump.

    Tighten:  Tighten the power steering pressure hose to 30 N.m (22 lb ft).

    7. Fig 3: Disconnecting/Reconnecting Power Steering Return Hose At Power Steering Pump
    GM183669Courtesy of GENERAL MOTORS CORP.
  7. Connect the power steering return hose to the power steering pump.
  8. Lower the vehicle.
  9. Install the drive belt. Refer to Drive Belt Replacement (L36) in Engine Mechanical - 3.8 L.
  10. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  11. Inspect the power steering system for leaks.
scientia non olet · About LEMON Manuals