LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2000 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2  or to SIR Disabling and Enabling Zone 6 .
  2. Removal of passenger or driver inflatable restraint side impact sensor (SIS) use the same procedure.
  3. Move the seat to the full forward position.
  4. Remove the center pillar trim panel. Refer to Garnish Molding Replacement - Center Pillar in Interior Trim.
    5. Fig 1: Removing/Installing Inflatable Restraint Side Impact Sensor
    GM457510Courtesy of GENERAL MOTORS CORP.
  5. Remove the connector position assurance (CPA) (5) from the inflatable restraint side impact sensor (SIS) harness connector (4).
  6. Disconnect the SIS harness connector (4) from the SIS (2).
  7. Remove the SIS mounting fasteners (1).
  8. Remove the SIS (2) from the center pillar sheet metal (3).
scientia non olet · About LEMON Manuals