LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2000 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement (AM6) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
    2. Fig 1: View of SDM Mounting Fasteners, SDM, and Console Floor
    GM464950Courtesy of GENERAL MOTORS CORP.
  2. Install the SDM (2) horizontally to console floor (3).
  3. Point the arrow on the SDM toward the front of the vehicle.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the SDM mounting fasteners (1).

    Tighten:  Tighten the fasteners to 9 N.m (80 lb in).

    5. Fig 2: View of DM Wiring Harness Connector, SDM & Push-On Clip
    GM464945Courtesy of GENERAL MOTORS CORP.
  5. Connect the SDM wiring harness connector (3) to the SDM (2).
  6. Install the push-on clip (1) securing the SDM wiring harness to the console stud.
    7. Fig 3: View Of Connector Position Assurance (CPA) Flex Lock Button
    GM466123Courtesy of GENERAL MOTORS CORP.
  7. Push down flex lock button (3) and then move sliding connector locking cover (4) to the close position.
  8. Install the CPA (1) to the inflatable restraint SDM wiring harness connector (2).
    9. Fig 4: Identifying Split Bench Front Seat & Components
    GM381863Courtesy of GENERAL MOTORS CORP.
  9. Install the rear carpet into vehicle. Refer to Carpet Replacement - Rear in Interior Trim.
  10. Install the front split bench seat. Refer to Seat Replacement - Split Bench in Seats.
  11. Enable the SIR system. Refer to, SIR Disabling and Enabling Zone 8 .
    12. IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly.
  12. Program the new SDM into the dash integration module (DIM). Refer to Body Control Module (BCM) Programming/RPO Configuration (IPM) or Body Control Module (BCM) Programming/RPO Configuration (DIM) or Body Control Module (BCM) Programming/RPO Configuration (RIM) in Computer/Integrating Systems.
scientia non olet · About LEMON Manuals