LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2000 >> LeSabre Custom, 4T65E/M15 >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (HVAC System - Automatic) >> Repair Instructions >> Blower Motor Control Processor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the blower motor control processor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the retaining screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

    3. Fig 1: View of Blower Control Module, and HVAC Module
    GM419246Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (1).
  4. Install the DIM bracket screws.

    Tighten:  Tighten the screw to 1.4 N.m (12 lb in).

  5. Install the DIM into the bracket.
  6. Install the instrument panel compartment. Refer to Storage Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
  7. Install the right sound insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals