LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2000 >> LeSabre Custom, 4T65E/M15 >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Theft Deterrent System) >> Repair Instructions >> Theft Deterrent Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  1. Install the theft deterrent control module (2) onto the ignition lock cylinder case assembly (1).
    2. CAUTION: Refer to SIR Inflator Module Coil Caution in Cautions and Notices.
  2. Connect the connector to the theft deterrent control module.
  3. If necessary, connect the connector to the ignition lock cylinder case.
  4. Install the lock cylinder. Refer to Ignition Lock Cylinder Replacement in Steering Wheel and Column.
  5. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  7. Program the theft deterrent control module. Refer to Programming Theft Deterrent System Components .
scientia non olet · About LEMON Manuals