Removal & Installation
- Insert screwdriver behind front edge of inside door handle bezel and gently remove bezel. Look down into bezel opening in door trim panel. If a spring clip is visible, trim panel is late production. Use Door Trim Pad Remover (J-38778) to release fastener at top of shark fin. Lift upwards to remove, disconnect wire harness connector for speaker.
- Remove door light or reflector and remove fastener in opening. On late production, using a thin flat bladed tool, pry forward edge of wood grain panel away from door trim panel. Remove screw behind panel. On all models, release door panel retainers with Clip Zip Tool (J-36796) and disconnect door panel wiring harness. Remove door panel.
- Disconnect electrical connectors. Remove door module fasteners and remove door module. To install, reverse removal procedure.