LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2000 >> Century Custom >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 (Body Control Modules) >> Self-Diagnostic System >> Clearing Body Control Module Diagnostic Trouble Codes >> Without Power Door Locks

Without Power Door Locks

WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to RUN position to deactivate Content Theft Deterrent (CTD) alarm system (if equipped). Turn ignition switch to OFF position. Remove RADIO fuse No. 17 (15-amp) from instrument panel fuse block. See Figure. RADIO fuse is located in lower right-hand corner of fuse block.
  2. Turn ignition switch to ACC position. Chime will sound 1-2 times to verify system has entered programming mode for customizing special features. Within 5 seconds, turn ignition switch to OFF position, then immediately back to ACC position. Chime will sound 3 times to verify Body Control Module (BCM) has entered diagnostic mode.
  3. Using a fused jumper wire connected to ground, backprobe BCM connector C1 terminal "D" (Orange/Black wire) for 4 seconds. See Fig 1. After 4 seconds, chime will sound 3 times to confirm DTCs have cleared. To exit diagnostic mode, turn ignition switch to OFF position. Install RADIO fuse.
    Fig 1: Identifying Body Control Module Harness Connectors & Terminals
    G99E08630Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals