Strut Assembly: Installation
CAUTION:
Use the correct fasteners in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fasteners torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
CAUTION:
Care should be taken to avoid chipping or scratching the coating when handling the suspension coil spring. Damage to the coating can cause premature failure.
- Install strut into place.
- Install the strut to knuckle bolts (2). Tighten the strut to knuckle bolts. See TORQUE SPECIFICATIONS .
- Connect the stabilizer shaft link to the strut. See STABILIZER SHAFT LINK section.
- Install tire and wheel.
- Install the three strut-to-body mount nuts.
- Install three strut to body mount nuts. Tighten the strut to body mount nuts. See TORQUE SPECIFICATIONS .
- Lower the vehicle.
- Adjust the rear wheel alignment.