LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1998 >> Century Custom >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Module >> Diagnostic Tests >> DTC U1300: Class 2 Circuit (Short To Ground) >> Testing

DTC U1300: Class 2 Circuit (Short To Ground): Testing

  1. Perform Data Link Connector (DLC) diagnostic system check. Go to DLC DIAGNOSTIC SYSTEM CHECK. After DLC diagnostic system check is performed, go to next step.
  2. If BCM diagnostic system check was performed, go to next step. If BCM diagnostic system check was not performed, see procedures in BCM DIAGNOSTIC SYSTEM CHECK  .
  3. Turn ignition switch to RUN position. Using scan tool, clear DTCs. Check for DTCs. If DTC U1300 is set, go to next step. If DTC U1300 is not set, go to step 5).
  4. Replace BCM. See REMOVAL & INSTALLATION  . Reprogram BCM. See procedures in BCM PROGRAMMING  . Go to step 6).
  5. System is operating properly at this time. See DIAGNOSTIC AIDS. After any repairs are made, go to next step.
  6. Turn ignition switch to LOCK position. Reinstall all components and connectors. Turn ignition switch to RUN position. Using scan tool, clear DTCs. Check for DTCs. If any DTCs are current, perform BCM DIAGNOSTIC SYSTEM CHECK  . If no DTCs are current, system is operating properly.
scientia non olet · About LEMON Manuals