LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1997 >> Century Custom >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Removal & Installation >> Transverse Spring Assembly >> Installation

Transverse Spring Assembly: Installation

  1. To install, partially compress spring. Engage spring into hole in left knuckle, slide spring toward left as far as possible and raise right end as far as possible. Compress spring further and slide into right knuckle.
    2. CAUTION: Spring retention plates have tabs on one end. Ensure tabs are aligned with crossmember support to prevent fuel tank damage.
  2. Center spring to align holes for spring retention plates. Install spring retention plates, but DO NOT fully tighten bolts. Connect right trailing arm to knuckle. Tighten bolt to specification. See TORQUE SPECIFICATIONS  table. Connect ABS electrical connector (if equipped). Remove rear spring compressor. Tighten spring retention plate bolts to specification. Install jack pad. Connect exhaust system (if applicable).
scientia non olet · About LEMON Manuals