Pull-In Windings Test

Connect test equipment as in hold-in windings test. See HOLD-IN WINDINGS TEST. See Fig 1 . Ground starter solenoid terminal "M". Turn switch on and quickly adjust carbon pile load until voltage reads as specified. See PULL-IN WINDINGS SPECIFICATIONS table. Check ammeter reading. Turn off carbon pile and open switch. See PULL-IN WINDINGS SPECIFICATIONS table. If ammeter reading is not as specified, replace starter solenoid.

PULL-IN WINDINGS SPECIFICATIONS

Engine

Starter Motor

Amps

2.2L & 3.1L

SD205

⁽¹⁾ 60-85

⁽¹⁾	At 10 volts.

Fig 1: Solenoid Winding Test Connections (Century & Ciera)

Courtesy of GENERAL MOTORS CORP.