LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1994 >> LeSabre Custom >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Anti-Theft System >> Testing >> Pass-Key II(R) System Testing >> PASS-Key II(R) System Verification

PASS-Key II(R) System Verification

  1. Ensure system will detect use of incorrect key by turning off engine. Disconnect PASS-Key II(R) connector at base of steering column. Connect Interrogator (J-35628) to connector. Set key code on interrogator to an incorrect key code. Attempt to start engine.
  2. If engine cranks, replace PASS-Key II(R) decoder module and repeat PASS-KEY II(R) DIAGNOSTIC SYSTEM CHECK. If engine does not crank within 3-minute lock-out period while SECURITY indicator is on, turn ignition off. Disconnect interrogator and reconnect connector at base of steering column. Attempt to start engine. If engine cranks, replace decoder module and repeat PASS-KEY II(R) DIAGNOSTIC SYSTEM CHECK.
  3. If engine does not crank, turn ignition switch to OFF position. Wait at least 3 minutes until end of lock-out period and attempt to start vehicle. If engine does not start, see NOTES ON INTERMITTENTS  . If engine starts, system is functioning correctly. If an intermittent problem is suspected, see NOTES ON INTERMITTENTS  .
scientia non olet · About LEMON Manuals