2-4 Band & Servo Assembly
- Install 2-4 band in case. Align band anchor pin end with case pin hole. Install band anchor pin in case. Ensure band anchor pin aligns with end of 2-4 band.
- Install 2-4 servo assembly into case, and index apply pin on band end. Check for proper engagement of apply pin on band end. Recheck 2-4 servo apply pin selection to ensure correct pin is installed. See CHECKING SERVO PIN LENGTH
under TRANSMISSION DISASSEMBLY. Different length servo pins are available. See SERVO PIN SPECIFICATIONS
. Select proper length servo pin.
SERVO PIN SPECIFICATIONS
| Pin ID |
Pin Length: In. (mm) |
| 2 Rings |
2.61-2.62 (66.3-66.5) |
| 3 Rings |
2.67-2.68 (67.8-68.1) |
| Wide Band |
2.72-2.73 (69.1-69.3) |
- Install servo cover and "O" ring. Install Servo Cover Compressor (J-29714), and compress cover. Install cover retaining ring, indexing ring ends with slot in case.