Brake (Stoplight) Switch
CAUTION:
When installing stoplight switch assembly into bracket, DO NOT apply more than 25 ft. lbs. (33.9 N.m) of side load pressure on harness connector terminals.
NOTE:
Stoplight switch may also be referred to as cruise/shift interlock/brake shift switch, brake switch or brake switch.
- Install harness connectors and cruise vacuum line on stoplight switch. See Fig 1 . Fully depress brake pedal. Insert switch assembly into mounting bracket. Press switch assembly inward until no clicks are heard.
- Pull brake pedal rearward until no clicks are heard. Release pedal and pull it rearward again to ensure switch assembly is fully seated.
- When properly installed, notch in switch plunger should be visible. See Fig 1 . If assembly is not properly installed, repeat steps 1 and 2 ,