Displaying Trouble Codes
- The Electronic Control Module (ECM), Body Control Module (BCM), and Supplemental Inflatable Restraint (SIR) trouble codes automatically display after system enters self-diagnostics. ECM trouble codes are displayed first, followed by the BCM trouble codes and then SIR trouble codes.
- All trouble codes appear in an ascending (3 digit) numerical order. ECM codes are prefixed with the letter "E", BCM Codes prefixed with the letter "B", and SIR codes prefixed with the letter "R".
- In addition, all trouble codes are followed by the letter "C" or "H". Letter "C" stands for current and indicates a trouble code related fault presently exists. Letter "H" stands for history and indicates the system failure was not present the last time the code was accessed.
- For example: Code E016H is ECM trouble code number 016, set in response to a malfunction that occurred in the past (history). Code B410C is BCM trouble code number 410, set in response to a malfunction that is currently taking place.
- If no ECM, BCM or SIR trouble codes are stored in memory, respectively, a NO E CODE, NO B CODE or NO R CODE message is displayed. Should the communication link between a component and the ECM or BCM fail, a NO B DATA, NO E DATA, or NO R DATA message will be displayed.
- Trouble code display can be by-passed at any time by depressing FAN DOWN button on ECCP.
ECM TROUBLE CODES
| Code | Circuit Affected |
|---|---|
| E013 | Open O2 Sensor Cicuit |
| E014 | Coolant Sensor Temperature Too High |
| E015 | Coolant Sensor Temperature Too Low |
| E016 | Battery System Voltage Too High |
| E021 | TPS Signal Voltage High |
| E022 | TPS Signal Voltage Low |
| E023 | MAT Sensor Circuit Temperature Low |
| E024 | Vehicle Speed Sensor (VSS) Circuit |
| E025 | MAT Sensor Circuit Temperature High |
| E026 | Quad-Driver Circuit |
| E027, 28 & 29 | Gear Switch Diagnosis |
| E031 | Park/Neutral Switch Circuit |
| E034 | MAF Sensor Circuit |
| E038 | Brake Switch Circuit |
| E039 | Torque Converter Clutch (TCC) Circuit |
| E041 | Cam Sensor Circuit |
| E042 | Electronic Spark Timing (EST) Circuit |
| E043 | Electronic Spark Control (ESC) Circuit |
| E044 | Oxygen Sensor Circuit Lean |
| E045 | Oxygen Sensor Circuit Rich |
| E046 | Power Steering Pressure Switch Circuit |
| E047 | ECM-BCM Data |
| E048 | Misfire Diagnosis |
| E051 | MEM-CAL Error |
| E058 | VATS Fuel Enable Circuit |
| E063, 64 & 65 | EGR Circuit |
NOTE:
To repeat trouble code display sequence again, depress OFF button on ECCP.