LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1987 >> Electra Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - 200-4R >> Transmission Reassembly >> Front Unit Parts

Front Unit Parts

  1. Install intermediate band into case, locating band apply lug and anchor pin lug in case slot. Install band anchor pin.
  2. Position direct clutch assembly, clutch plate end up, over hole in work bench. Align teeth of composition plates in direct clutch. Install forward clutch assembly, shaft first, into direct clutch assembly. Hold direct clutch and rotate forward clutch back and forth until fully seated.
    NOTE: When forward clutch is fully seated, it will be approximately 5/8" from tang end of direct clutch housing to end of forward clutch drum.
  3. Install direct and forward clutch assemblies into case and rotate into position. When assemblies are correctly installed, it will be approximately 4 1/8" from pump face in case to direct clutch housing.
  4. Install center support-to-direct clutch thrust washer on center support. Visually align center support with case bolt holes and install center support into case. Install, but DO NOT  tighten, center support attaching bolts. Install center support-to-case snap ring with beveled side up. Tighten center support attaching bolts.
NOTE: At this point, recheck input shaft end play to verify that correct front selective washer has been installed. See INPUT SHAFT END PLAY  .
scientia non olet · About LEMON Manuals