Cooling System Servicing: Maintenance: Flushing

CAUTION: Some manufacturers may use an aluminum/plastic radiator on some models (identified by a note below the filler neck). According to manufacturer's recommendations, material used for cleaning and flushing must be compatible with aluminum.

Back flushing is a very effective means of removing rust and scale from a cooling system. For best results the radiator, engine and heater core should be flushed separately.
To flush radiator, connect flushing gun to water outlet of radiator and disconnect water inlet hose. To prevent flooding engine, use a leadaway hose connected to radiator inlet. Use air in short bursts only; this will prevent damage to radiator. Continue flushing until water runs clear.
To flush engine, first remove thermostat and replace housing. Connect flushing gun to water outlet of engine. Disconnect heater hoses from engine. Flush using short air bursts until water runs clean. Flush heater core as described for radiator. Make sure heater valve is set to maximum heat position before flushing heater.