LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1987 >> Electra Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> CCC Components Removal & Installation >> Removal & Installation >> Programmable Read Only Memory (Prom) >> Installation

Programmable Read Only Memory (Prom): Installation

  1. Check that new PROM has same service number as old one. Place new PROM in PROM carrier. Position squarely over ECM PROM socket. Press on PROM carrier until PROM is firmly seated in ECM.
    NOTE: Make sure that reference notches in both ECM and PROM are properly aligned. If PROM is installed backwards and key is turned on, PROM will be destroyed.
  2. Reinstall PROM access cover on ECM. Reinstall ECM in vehicle as previously described. Start engine and ground diagnostic test lead. Watch for trouble Code 51.
  3. If this occurs, PROM is not fully seated in ECM, installed backwards, has bent pins or is defective. If pins are bent and crack when straightened, PROM must be replaced. If PROM is installed backwards or is defective, it must be replaced.
scientia non olet · About LEMON Manuals