Maintenance And General Information -- Repair (IX)
- 00 00 General Maintenance
- Brake lines and connections: visual inspection for leaks, damage, attachment and correct position
- Care measures for vehicles in stock (new and used vehicles) as well as vehicles to be decommissioned in customer hands
- Check horn, headlight flashers and hazard warning flashers
- Checking for traffic safety (test drive)
- Checking instrument/inscription lighting, interior/trunk/glove box lights and blower
- Checking lighting system
- Check windshield wash/wipe system
- Safety belts: Check condition of seat belt strap, check function of electrically motorized reel, seat belt locking reel, seat belt buckle, seat belt clip and, if necessary, seat belt clasp
- Steering components: Check for play and damage
- Tires: checking and if necessary correcting inflation pressure, checking condition, tread depth and pattern
- Underbody including all visible components: Check for damage, correct position, tightness, corrosion
- When driving on a race track
- Windshield washer system: checking fluid level, topping up if necessary
- Work instruction for removing the protective film
- 00 00 009 Free pre-delivery check
- Reset transport mode and perform pre-delivery check with diagnostic system
- Checking Check Control messages
- Check that navigation map is up-to-date and valid in the relevant country
- Checking pre-delivery check entry in service history
- Checking the tire pressure and resetting the Tire Pressure Monitor
- Checking tire pressure (only while using Tire Pressure Monitor SA2VB)
- For winter tires: Attach the label for top speed
- Checking implementation of country-specific requirement for BMW Roadside Assistance
- Top off the washer fluid for the washer system
- Enclosing documents
- Installing accessory items
- Checking all vehicle keys for proper operation, activating Key Card and placing in vehicle
- Enclosing the charging cable
- 00 00 105 Standard scope of service
- 00 00 612 Service - front brakes
- Removing the front brake pads
- Measuring brake disk thickness (front brake)
- Grease brake pads, brake anchor plate and brake caliper with brake pad paste
- Installing front brake pads
- Placing the brake pads on the brake disk/putting them into operation
- Adhesion of brake pads to brake pistons
- Removing front brake pads (17 inch Low brake)
- Grease the brake pads, the brake anchor plate and the brake caliper with the brake pad paste (17-inch low brake)
- Install front brake pads (17-inch Low brake)
- 00 00 614 Rear brakes service
- 00 00 616 Service - cabin air filter
- 00 00 618 Brake fluid service
- 00 00 624 Vehicle check service
- Checking the charging cable and the high-voltage charging socket
- Checking positioning of charging cable
- Check horn, headlight flashers and hazard warning flashers
- Checking lighting system
- Checking the windshield wipers and the washer system
- Replace battery of the remote control key(s)
- Check blower
- Check tires (if available, emergency wheel also)
- Programming wheel electronics (only while using Tire Pressure Monitor SA2VB)
- Moving the hood to the service position
- Cleaning the windshield panel and equipment compartment
- Top off the washer fluid for the washer system
- Checking coolant level and coolant composition
- Checking engine compartment from above for leaks
- Close the engine compartment lid
- Checking the underbody and all visible components
- Perform the CBS reset
- Checking for traffic safety and performing test drive
- 00 00 691 Additional work, service vehicle check (in connection with vehicle check service only)
- 00 02 Vehicle Lifting
- 00 11 Electric Drive Unit Oil