Program/encode the optional equipment system (SAS)
Precondition
The control unit was replaced.
NOTE:
TECHNICAL INFORMATION
Use the most recent software version to prevent faults during programming/coding.
Battery voltage must not drop below 13.0 V during programming.
Only use chargers recommended by BMW for low-voltage vehicle electrical systems.
Use the most recent software version to prevent faults during programming/coding.
Battery voltage must not drop below 13.0 V during programming.
Only use chargers recommended by BMW for low-voltage vehicle electrical systems.
NOTE:
TECHNICAL INFORMATION
No high-voltage switch off is required in electric vehicles or hybrid vehicles for programming/coding.
The high-voltage system will be automatically switched off by the programming system.
Exception:
BMW I01: Note Product and Measures Management Aftersales measure 55176388.
No high-voltage switch off is required in electric vehicles or hybrid vehicles for programming/coding.
The high-voltage system will be automatically switched off by the programming system.
Exception:
BMW I01: Note Product and Measures Management Aftersales measure 55176388.
- Connect the battery charger to the vehicle.
- Connect the programming system with the vehicle.
- Determine the action plan.
- Accept and fully process the action plan.
- Depending on the reworking list, connect the workshop system to the vehicle if necessary.
- Carry out vehicle test.
- Delete the fault memory.
- Note the information on programming in the workshop system and the relevant information in the user documentation.
- Wait until programming/coding has been completed.
- Disconnect the programming system from the vehicle.
- Disconnect the battery charger from the vehicle.