Replacing pressure sensor on intake plenum (N55T0 Engine) (2016-2018)
Necessary preliminary tasks:
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove IGNITION COIL COVER .
- Partially release ignition coil cover.
Unlock connector (1) and remove.
Release screws and pull differential-pressure sensor (2) out of intake plenum.
Tightening torque 13 62 4AZ .
Installation note:
Check sealing ring for damage. Replace damaged sealing ring.
When installing, coat sealing ring with suitable lubricant.
NOTE:
Reassemble the vehicle.
Check stored fault message.
Delete fault memory.
Check stored fault message.
Delete fault memory.