37 15... Removing and installing/replacing control unit for vertical dynamics management

WARNING: This page is about a different car, the 2014 BMW X6 M, 2013 BMW X6 M, 2012 BMW X6 M, 2011 BMW X6 M, and 2010 BMW X6 M. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove ignition key
Disconnect BATTERY NEGATIVE LEAD .
Remove FLAP IN LUGGAGE COMPARTMENT PANEL ON RIGHT .

Lift back insulating mat (1).

Fig 1: Identifying Insulating Mat

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unlock catches (2) and remove control unit (3).

Fig 2: Identifying Plug Connection, Catches And Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Replacement only: Carry out PROGRAMMING/CODING .
Replacement only: Carry out RIDE-HEIGHT-CALIBRATION .