Reset Ultra-Small Quantity Adaptation
NOTE:
TECHNICAL INFORMATION
If the DME control unit or an injector is replaced, minimum quantity adaptation must be reset. If an injector has been replaced on cylinder side, the minimum quantity adaptation must also be reset.
If the DME control unit or an injector is replaced, minimum quantity adaptation must be reset. If an injector has been replaced on cylinder side, the minimum quantity adaptation must also be reset.
- Connect the diagnostic system and reset the minimum quantity adaptation:
- Read out vehicle data
- Identification with vehicle test
- Start vehicle test
- Vehicle handling
- Service functions
- Drive
- Engine electronics
- Reset adaptation values
- Fuel system adaptation values
- Continue service function