1112 Cylinder Head
11 12 CYLINDER HEAD WITH CYLINDER HEAD COVER - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Cylinder head bolt | S55 | M11x173 | Replace screws. | |
| Jointing torque | 30 Nm | |||
| 1) Angle of rotation | 90° | |||
| 2) Angle of rotation | 180° | |||
| 2AZ Cylinder head bolt | S55 | M9x30 M9x70 |
22 Nm | |
| 3AZ Cylinder head cover to cylinder head. | S55 | M6 | 9 Nm | |
| 4AZ Towing lug to cylinder head | S55 | Hand-tighten to limit position | ||
| 5AZ Ignition coils and injector slot to cylinder head | S55 | M6x35 | 9 Nm | |
| 6AZ Wiring harness to cylinder head cover | S55 | D10L43.5 | Self-tapping screw (ball pin) | 7 Nm |
| 7AZ Heat shield support to cylinder head | S55 | M6x16 | 10 Nm | |
| 8AZ Ground strap to rear of cylinder head | S55 | M6x16 | 8 Nm | |
| 9AZ Battery voltage wire holder to cylinder head | S55 | M7x18 | 13 Nm | |
| 10AZ Blow By line with heating to clean air pipe of cylinder 1-3 | S55 | Ejot drive train 50x 20 | 3 Nm | |
| 11AZ Screw plug in oil chamber | S55 | M 16x1.5 | Replace screw with sealing ring. | 27 Nm |
| 12AZ Sealing flange of servomotor to cylinder head cover | S55 | M6x18 | Self-tapping screw | 6 Nm |
| 13AZ Stud bolt of exhaust manifold (turbocharger) to cylinder head | S55 | M7 | 8 Nm |
| Flange to assembly jig | M14X30 | Tightening torque | 135 Nm |