12 90... Removing and installing/replacing electronics box

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

NOTE: Follow instructions for removing and installing CONTROL UNITS !

Necessary preliminary work:

Release screws (1).

Tightening torque 12 90 1AZ .

Unclip coolant lines at clamp (2) from electronics box.

Feed electronics box (3) out upward and remove.

Fig 1: Identifying Electronics Box, Clamp And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

When installing the electronics box, insert guide (1) on engine support.

Fig 2: Identifying Guide

Courtesy of BMW OF NORTH AMERICA, INC.