Install front panel, center
WARNING: This page is about a different variant/trim than selected.
- Install the center front panel (3).
- Slide the securing pin (2) into the rubber mounts in the direction of the arrow and lock the locks (1).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Front panel, middle, on carrier support | |
| M8x27 | 28 Nm |
TIGHTENING TORQUE SPECIFICATIONS
| Headlight to center front panel | |
| 5 Nm | |
- Attach the bonnet lock on the center front panel with the screws (2).
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Front lock support to support | |
| 11.8 Nm | |
- Tighten down screws (3).
TIGHTENING TORQUE SPECIFICATIONS
| Center front panel to support | |
| 11.8 Nm | |
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Air duct to center front panel | |
| 5 Nm | |
- Replace screws (2).
Parts: Bolts
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Support to center front panel | |
| Replace screws. | 19 Nm |