32 31 211 Removing And Installing/Replacing Universal Joint With Corrugated Tubing (M5)

IMPORTANT: If the lower section of the steering shaft is separated from the steering box/steering shaft middle section, the steering column switch cluster may be damaged when the steering wheel is turned.

Necessary preliminary tasks:

Remove rear UNDERBODY PROTECTION .
Remove REINFORCEMENT PLATE .

Release screw (1) on corrugated tubing.

Tightening torque: 32 31 3AZ .

Fig 1: Corrugated Tubing Screw Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) from below.

Tightening torque: 32 31 2AZ .

Slide universal joint with corrugated tubing upwards and remove.

Installation note:

Connect universal joint with corrugated tubing first to steering shaft and then to steering box.

Clean screw threads to remove all remnants of screw locking adhesive.

Fig 2: Screw For Steering Shaft Lower Section

Courtesy of BMW OF NORTH AMERICA, INC.

Replace screws.

Screw must rest in steering box groove or steering shaft middle section.

No subsequent retorquing permitted!

After installation:

Turn steering wheel in both directions to the limit position. The airbag indicator light must not light up in the process.