32 41 435 Removing And Installing/Replacing Dynamic Drive Return In Front Right Wheel Arch

Special tools required:

32 1 270

WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin!
DANGER OF INJURY if oil comes into contact with eyes and skin!

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Do not draw off hydraulic fluid (risk of contamination).
Close off line connections with seal plug. 32 1 270

Recycling:

Catch and dispose of hydraulic fluid in a suitable collecting vessel.

Necessary preliminary work:

Remove FRONT RIGHT WHEEL ARCH COVER .
Remove underbody protection at front and rear . See 51 47 491 REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION or 51 47 491 REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION .
Remove right STEERING ASSEMBLY COVER .
Release front right UNDERBODY PANELLING .

IMPORTANT: Pressure lines must be closed off with suitable seal plugs 32 1 270 immediately after removal!

Release screw (1) for return line.

Fig 1: Screw For Return Line

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Attention:

When tightening the screw connection (1), apply counter support with wrench (3) at the line (2)!

Non-compliance will result in damage to the line (2)!

Tightening torque: 37 13 12AZ .

Fig 2: Connection, Line And Pliers

Courtesy of BMW OF NORTH AMERICA, INC.

Release line clips (1) and (2) from front axle support.

Fig 3: Line Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) in area of lower wishbone.

Tightening torque: 32 41 15AZ .

Fig 4: Screw In Area Of Lower Wishbone

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: When assembling, make sure that in succession only the seal plugs of the line to be fitted are removed.
When fitting lines, do not tilt connectors (sealing rings!) and connect fully before screwing.
Do not replace sealing rings on hydraulic lines.
Replace affected line if sealing ring is damaged.

After installation:

Carry out INITIAL DYNAMIC DRIVE OPERATION .
Check line connections for tightness.