Stratification control wheel
Two stratification controls are fitted for the IHKA:
- Front center ventilation grille
- Rear compartment ventilation grille
The selected potentiometer setting is implemented on the flap position of each flap motor.
The signals from the stratification controls are sent to the IHKA control unit via 2 signal lines. The IHKA control unit evaluates the information and activates the flap motors.
The stratification controls have a liner resistance value determined by the angle of rotation. The limit-position switches are switched on and off mechanically via eccentric washers. Using the limit-position switch, the following ventilation flap positions in the ventilation grille are recorded: