51 00... Notes on component bonding adhesive tape

1. General notes

• Bonding at room and object temperature of >+18 °C.
• Newly painted parts may only be bonded after a drying time of at least 24 hours.
• Optimal bonding/attachment to the background surface is achieved after approx. 48 hours. Components must not be exposed to mechanical strain beforehand (car wash, strength test, etc.).
• Do not touch bonding surface.
• It is not the length of time that pressure is applied but rather the force of pressure applied that is crucial.
• Detaching the adhesive tape after pressing destroys the adhesive layer.
• After being pressed on gently, adhesive tape can be pulled off again up to 3 times.

2. Auxiliary materials and tools

• CLEANING AGENT R1 OR CLEANING AGENT R2 (sourcing reference: BMW Parts Department)
• Fluff-free cleaning cloths
• Pressure roller

3. Preparations

• Remove all adhesive residue or clean new part thoroughly
• Clean the areas to be bonded immediately before bonding to remove silicone and grease residues.

4. Bonding

4.1 Components without pre-fitted adhesive tape

• Pull off liner* from adhesive tape
• Position adhesive tape on component and stick on
• Press down adhesive tape over entire adhesive area
• Continue with Point 4.2

* Liner is the protective film on the adhesive tape

4.2 Components with pre-fitted adhesive tape

• Pull off liner* from adhesive side (if adhesive area is large, do not pull off liner completely)
• Align component in correct position on vehicle
• Press down component over entire adhesive area

* Liner is the protective film on the adhesive tape