61 35 360 Removing and installing/replacing control unit for camera-based driver assistance systems (KAFAS)

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Disconnect NEGATIVE BATTERY CABLE
Remove both battery earth leads at F03
Remove trim panel for pedal mechanism. See TRIM PANEL (US ONLY) or TRIM PANEL (ECE ONLY) .

Disconnect plug connection (1).

Release screw (2).

Tightening torque: see 2AZ in 61 35 CONTROL UNITS .

Pull control unit (3) out of equipment carrier (4) in direction of arrow.

Installation note:

Make sure control unit (3) is correctly installed in equipment carrier (4).

Fig 1: Pulling Control Unit Out Of Equipment Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out calibration: