61 31 008 Removing and installing steering column switch cluster
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Move wheels into straight-ahead position and do not alter this position during the repair work.
Do not under any circumstances turn the steering column switch cluster when the steering wheel is removed.
Do not under any circumstances turn the steering column switch cluster when the steering wheel is removed.
Necessary preliminary tasks:
- Remove steering wheel. See STEERING WHEEL or SPORT STEERING WHEEL .
Unclip steering column shroud upper and lower sections (1).
Unfasten screws (2).
Tightening torque 61 31 3AZ .
Remove steering column switch cluster (3) in direction of arrow.
Installation note:
Not applicable to: F25
Carry out STEERING ANGLE SENSOR ADJUSTMENT .
On vehicles with active front steering, steering angle sensor adjustment is performed by means of START-UP / adjustment of active front steering.
Disconnect plug connection (1).
Remove steering column switch cluster (2).
Replacement:
Not applicable to F25.
- Carry out VEHICLE PROGRAMMING/ENCODING .
- Carry out STEERING ANGLE SENSOR ADJUSTMENT
- Vehicles with active steering:
- Steering angle sensor is adjusted by means of INITIAL OPERATION / ADJUSTMENT of active front steering