61 35 107 Removing and installing or replacing junction box electronics

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .

Necessary preliminary tasks:

Partially remove POWER DISTRIBUTION BOX FOR PASSENGER COMPARTMENT

Release screws (1) on junction box electronics (2).

Tightening torque 61 14 2AZ.

Fig 1: Identifying Junction Box Electronics With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Pull junction box electronics (2) out of bracket.

Installation note:

Make sure junction box electronics and plug connections (1) are correctly seated.

Fig 2: Identifying Junction Box Electronics With Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/CODING .

Delete transport mode.