61 00... Notes on handling optical fibres

IMPORTANT: To avoid damage when handling optical fibres, comply with the following points:

The minimum permitted bending radius is 25 mm.
Do not subject optical fibres to compressive and tensile load.
Protect optical fibres against the effects of heat ≥85 °C (e.g. during welding work, drying work with infrared heater or hot air blower).
Fibre-optic cables are permitted to show only one junction point (bridge), replace fibre-optic cables if necessary.

NOTE: The optical fibres are colored differently as follows:

Green = MOST (M edia O riented S ystems T ransport) optical fibre.
Yellow = ISIS (I ntelligent S afety and I ntegration S ystem) fibre-optic cable.
Orange=repair fibre-optic cables.