63 12 895 Replacing Electronics Box/Control Unit For Left Adaptive Headlight

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 335xi, 2013 BMW 335is, 2013 BMW 335i, 2012 BMW 335xi, and 2012 BMW 335is. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore, before removing, disconnect all components from the voltage supply (lighting system and ignition off).
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.

IMPORTANT: Read and comply with protection against electrostatic damage (ESD PROTECTION) .

Necessary preliminary tasks

Remove LEFT HEADLIGHT

NOTE: Operation is shown by way of example on the E70.

Release screws (1). Tightening torque 63 12 5AZ .

Remove electronics box/control unit for Adaptive Headlight (2) from headlight.

Installation note:

Make sure gasket is positioned correctly on electronics box/control unit for adaptive headlight (2).

Fit electronics box/control unit for Adaptive Headlight (2) exactly on headlight.

Make sure pin housing (3) is fitted correctly in connector housing (4).

Fig 1: Screws, Adaptive Headlight And Connector Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Carry out VEHICLE PROGRAMMING/CODING .