86 10... Replacing drawbar members, left and right

NOTE: Disassembly of overrunning equipment,
refer to 86 10... DISASSEMBLY OF OVERRUNNING EQUIPMENT .
Remove complete brake pull rod.
Removal of position light cable,
refer to 86 10... REPLACING LICENSE PLATE LIGHT .

Release screws (1) on cross-member (2). Pull out crossmember (2) towards rear.

Installation:

Tightening Torque,

refer to 86 10 16AZ, see 86 10 PLATFORM

Fig 1: Identifying Screws On Cross-Member

Courtesy of BMW OF NORTH AMERICA, INC.

Release countersunk head screws (1) and remove.

Installation:

Tightening Torque,

refer to 86 10 3AZ, see 86 10 PLATFORM

Fig 2: Identifying Countersunk Head Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable holder (1) and remove wiring harness (2) from drawbar member (3).

Fig 3: Identifying Cable Holder, Wiring Harness And Drawbar Member

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable (1) from position light housing (2). Pull out cable (1) through drawbar member aperture (3).

Fig 4: Identifying Cable, Drawbar Member Aperture And Light Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Release all screws on cross-member (1) and remove crossmember (1).

If necessary, release screws on mounting brackets (2) and remove cross-members (3).

Installation:

Use new self-locking nuts.

Tightening Torque,

refer to 86 10 17AZ, see 86 10 PLATFORM

Fig 5: Identifying Cross-Member And Mounting Brackets

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolt (1). Grip nut from rear through assembly hole (2) in cross-member.

Installation:

Use new self-locking nuts.

Tightening Torque,

refer to 86 10 18AZ, see 86 10 PLATFORM

Fig 6: Identifying Assembly Hole In Cross-Member

Courtesy of BMW OF NORTH AMERICA, INC.

Tilt drawbar member (1) down in direction of arrow A and pull out towards rear in direction of arrow B.

Fig 7: Removing Drawbar Member

Courtesy of BMW OF NORTH AMERICA, INC.