Programming Fails For The IHKA, FKA, Or Con (09 01 09)

WARNING: This page is about the 750i 4.4, N63, which is a different variant/trim than selected.

Publication date: 2009-04-08
Reference number: 09 01 09

PROGRAMMING FAILS FOR THE IHKA, FKA, OR CON

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI B 09 01 09, Date of Issue: April 8, 2009

BMW:	F01, F02 (7 Series); Vehicles produced up to November 12, 2008
GROUP:	Programming/Coding Explanations

Programming Fails for the IHKA, FKA, or CON

One of the following control modules fails to program with ISTA/P:

The wrong information has been stored in the memory range for the control modules, which causes programming of these control modules to fail.

Replace the control module that fails.

Covered under the terms of the BMW New Vehicle Limited Warranty.

WARRANTY INFORMATION

Defect Code:

Refer to KSD

Labor Operation:

Labor Allowance:

Description:

Refer to KSD⁽¹⁾

Refer to KSD

⁽¹⁾	Main Work - use this labor operation number when this is the only repair being performed, or if this is the main repair when performed along with other repairs at the same time. If this is not the main repair, refer to KSD for the associated (+) labor operation code.