86 10... Replacing drawbar members, left and right

NOTE: Disassembly of overrunning equipment,
refer to 86 10... DISASSEMBLY OF OVERRUNNING EQUIPMENT
Remove complete brake pull rod.
Removal of position light cable,
refer to 86 10... REPLACING LICENSE PLATE LIGHT

Release screws (1) on cross-member (2). Pull out cross-member (2) towards rear.

Installation:

Tightening Torque,

Fig 1: Identifying Screws On Cross-Member

Courtesy of BMW OF NORTH AMERICA, INC.

Release countersunk head screws (1) and remove.

Installation:

Tightening Torque,

Fig 2: Identifying Countersunk Head Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable holder (1) and remove wiring harness (2) from drawbar member (3).

Fig 3: Identifying Drawbar Member, Wiring Harness With Cable Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable (1) from position light housing (2).

Pull out cable (1) through drawbar member aperture (3).

Fig 4: Identifying Drawbar Member, Light Housing With Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Release all screws on cross-member (1) and remove cross-member (1).

If necessary, release screws on mounting brackets (2) and remove cross-members (3).

Installation:

Use new self-locking nuts.

Tightening Torque,

Fig 5: Identifying Cross-Member With Mounting Brackets

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolt (1). Grip nut from rear through assembly hole (2) in cross-member.

Installation:

Use new self-locking nuts.

Tightening Torque,

Fig 6: Identifying Assembly Hole And Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Tilt drawbar member (1) down in direction of arrow A and pull out towards rear in direction of arrow B.

Fig 7: Tilting Drawbar Member Down

Courtesy of BMW OF NORTH AMERICA, INC.